Nearly all of the time, companies will spend a lot of money to purchase their forklifts. It is vital, therefore to take proper care of your machinery to protect your investment into the long run. It is a good idea to know the procedures which are carried out during the care and maintenance of this piece of machine.
One of the best ways to tell how good the engine is working is by starting the lift truck up and listening closely to see how it runs. For instance, if there are any misses or knocks, the machine is defective and this must raise several issues. In addition listen closely for any squealing noise which come from the belts since these sounds would provide you with a wealth of information.
When performing maintenance, several of the main components you will need to pay attention to comprise the horn, safety warning devices, the overhead guard, the lights and the gauges. Any burnt out light bulbs or faulty components must be replaced as soon as they are noticed. It is also essential to inspect the wiring.
The battery compartment terminals must be cleaned when the above components have been inspected thoroughly. If the terminals are not clean, be sure to clean them well. Each battery cell must be inspected so as to make certain that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and after that change the filters. The transmission filter, fuel filters and the hydraulic filter have to be regularly replaced. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
When the oil change has been carried out and new filters have been fitted, visually inspect the drive axle from underneath the machine. Be sure to grease the axle if there is any grease fitting. Inspect the engine belts for any frays or cracks. If you find any, fix the problem accordingly. Afterwards, inspect each and every other component of the machine like the wheels. If any kind of concern or fault is detected, be certain to address it immediately in order to make certain the equipment is working at its safest and optimum levels.